10cm 40pin Male-to-Male Breadboard Jumper Cable Ribbon - Image one
10cm 40pin Male-to-Male Breadboard Jumper Cable Ribbon - Image two
Share this product:
Item#: 17153
There are no customer reviews for this product. Be the first one to write one!
This is a set of 40 jumper wires in a cable ribbon with a male connector or pin at each end. It is used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components, without soldering.
This type of cable ribbon is also know as DuPont cable.
Each ribbon can be easily broken down into smaller groups or even individual jumper wires by just pulling on the wires.
Specifications:
- 40pin Jumper Cable Ribbon
- Male breadboard pins on both ends
- 22 AWG wire
- Length: 10cm
Age:
18 +
18 +
Approx. Ship Size:
5.00 x 2.50 x 0.25 inches
12.70cm x 6.35cm x 0.64cm
5.00 x 2.50 x 0.25 inches
12.70cm x 6.35cm x 0.64cm
Weight:
0 lb 1 oz
0.02 kg
0 lb 1 oz
0.02 kg
Warning:
CHOKING HAZARD
Small parts. Not for children under 3 yrs.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
CHOKING HAZARD
Small parts. Not for children under 3 yrs.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
Customer Reviews
There are no customer reviews for this product. Be the first one to write one!
